Qubino Z-Wave Shutter
The QUBINO Z-Wave Tubular Motor Controller (by GOAP) is the world's smallest Z-Wave module able to control the motors of blinds, rollers, shades and Venetian blinds.
Z-Wave Plus certified
- Supports the connection of a temperature sensor
- Requires 3-wire (including neutral) installation
- Can measure the power consumption of connected device
The QUBINO Z-Wave Tubular Motor Controller is a Z-Wave Plus (500 series) controller for blind, roller and shade motors. It is designed to fit into an existing switch and enables you to wirelessly control blind motors using a Z-Wave enabled (921.42 MHz in AUS/NZ) controller and reports the motors actual power (Watts) and total power consumption (kWh). This device also supports precise positioning for motors equipped with mechanical or electronic switches.
The QUBINO Z-Wave Tubular Motor Controller allows the connection of a temperature sensor which can report the local temperature to your Z-Wave gateway allowing it to better meet your heating/cooling needs.
This product integrates with all Australian certified (921.42 MHz) Z-Wave Controllers including;
- Vera Edge/3/Lite
- Fibaro Home Center 2/Lite
Technical Specifications
RF Protocol
|
Z‐Wave Plus (500 series chip)
|
RF Frequency
|
921.42Mhz ‐ AU/NZ approved RF for Z‐wave
|
Z‐Wave device type
|
Z-Wave binary switch, routing slave
|
Power
|
230 VAC ± 10%
|
Load
|
2 x 920W (4A resistive @ 230V AC)
|
Power Consumption
|
< 0.7W
|
Operation Range
|
Up to 30m indoors (with no obstacles)
|
Application
|
Indoor use only
|
Operation temperature
|
10 ~ 40 °C
|
Storage temperature
|
‐10 ~ 60 °C
|
Weight
|
30g
|
Dimensions
|
41.8mm x 36.8mm x 16.9mm
|
Applicable Dangerous Goods Regulations | Not Applicable |
---|